Differences

This shows you the differences between two versions of the page.

--- public:rangex-pro-manual [2023/12/22 15:44] – laurin
+++ public:rangex-pro-manual [2024/12/09 18:01] (current) – ↷ Page moved from internal:public:rangex-pro-manual to public:rangex-pro-manual admin
@@ Line 1: / Line 1: @@
 ====== RangeX Pro Manual ======
-{{:public:rangex_pro_overview.jpg?800|}}
+{{:public:rangex_pro_overview.jpg?600|}}
 ===== General Information =====
@@ Line 69: / Line 69: @@
 {{:public:inav_rx_mapping.png}}
+==== Change Flight Modes ====
+To reassign buttons on your remote controller, assign AUX channels to each flight mode using Inav configurator.
+  * Connect the drone via USB port of the flight controller to your computer
+  * launch INAV configurator
+  * Connect to the correspondent port
+  * Navigate to "Modes" tab
+  * Choose AUTO for the mode in question and press the corresponding button on your TX
+  * Don't forget to hit save!
+{{:public:inav_modes.png}}
+=== **IMPORTANT** ===
+For all models that support GPS rescue: The GPS rescue should not be activated if you are within 50m of the starting point. If the drone is within 50m radius of the starting point and GPS rescue is activated, the drone will drop form the sky. Only activate GPS Rescue manually if the drone is more than 50m away from its starting point.
 ==== Binding your DJI Goggle ====
@@ Line 80: / Line 97: @@
 {{:public:dji-goggles-2.jpg?400|}}
 {{:public:dji_o3_bind.button.jpeg?400|}}
+==== LED Setup ====
+The LEDs can be turned on and off with your remote controller. The LEDs are soldered to the Crossfire diversity RX on channel 5. You can change the channel on Output 5 to your preferred switch in the menu of the crossfire Diversity RX after it has been bound to your remote.
+{{:public:Rangexpro_LED_setup.jpg?500|}}
@@ Line 97: / Line 120: @@
 {{:public:rangex_pro_compass_compressed.jpg}}
-==== LED Setup ====
-The LEDs can be turned on and off with your remote controller. The LEDs are soldered to the Crossfire diversity RX on channel 5. You can change the channel on Output 5 to your preferred switch in the menu of the crossfire Diversity RX after it has been bound to your remote.
-{{:public:Rangexpro_LED_setup.jpg?500|}}
-==== Change Flight Modes ====
-To reassign buttons on your remote controller, assign AUX channels to each flight mode using Inav configurator.
-  * Connect the drone via USB port of the flight controller to your computer
-  * launch INAV configurator
-  * Connect to the correspondent port
-  * Navigate to "Modes" tab
-  * Choose AUTO for the mode in question and press the corresponding button on your TX
-  * Don't forget to hit save!
-{{:public:inav_modes.png}}
-=== **IMPORTANT** ===
-For all models that support GPS rescue: The GPS rescue should not be activated if you are within 50m of the starting point. If the drone is within 50m radius of the starting point and GPS rescue is activated, the drone will drop form the sky. Only activate GPS Rescue manually if the drone is more than 50m away from its starting point.
 ===== Change Rates =====