Old Revisions

These are the older revisons of the current document. To revert to an old revision, select it from below, click Edit this page and save it.

2026/11/05 10:28 public:omnix – [13.3 Use Gopro Preset] laurin +141 B (current)
2026/11/05 10:28 public:omnix – [13.3 Use Gopro Preset] laurin +18 B
2026/11/05 10:27 public:omnix – [13.2 Final checks before the first flight] laurin +51 B
2026/11/05 10:25 public:omnix – [OMNIX 360 Build Guide] laurin +18 B
2026/11/05 10:25 public:omnix – [OMNIX 360 Build Guide] laurin +19 B
2026/11/05 10:21 public:omnix – [12.1 Apply the optional GoPro Labs test preset] laurin -754 B
2026/11/05 10:19 public:omnix – laurin -637 B
2026/11/05 10:00 public:omnix – [4.2 Prepare and solder the AIO pads] laurin -115 B
2026/11/05 09:59 public:omnix – [Check the lenght for the motor cables] laurin +135 B
2026/11/05 09:55 public:omnix – [3.4 Install the Gopro Mainboard] laurin -305 B
2026/11/05 09:35 public:omnix – [12.2 Inspect GoPro lens imaging and stitching] laurin -29 B
2026/11/05 09:35 public:omnix – [12.1 Inspect power, connectors and motor direction] laurin -60 B
2026/11/05 09:34 public:omnix – [11.2 Prepare the bottom carbon plate] laurin +344 B
2026/11/05 09:34 public:omnix – [11.3 Install the bottom plate] laurin -440 B
2026/11/05 09:33 public:omnix – [11.4 Fit lens covers and battery mount] laurin -458 B
2026/11/05 09:32 public:omnix – [11.1 Connect the Gopro Bec an Gopro Power Cable & Close the Frame] laurin +270 B
2026/11/05 09:32 public:omnix – [11.2 Prepare the bottom carbon plate] laurin -327 B
2026/11/05 09:30 public:omnix – [11.1 Recheck GoPro BEC, XT30 and capacitor holders] laurin -310 B
2026/11/05 09:28 public:omnix – [10.3 Mount the GPS module] laurin +24 B
2026/11/05 09:28 public:omnix – [10.2 Check the GPS cable connection and position] laurin ±0 B