Differences

This shows you the differences between two versions of the page.

--- public:omnix [2026/10/22 13:37] – laurin
+++ public:omnix [2026/10/22 15:55] (current) – laurin
@@ Line 9: / Line 9: @@
 ===== Parts needed =====
-  * OMNIX 360 carbon frame, top and bottom plates, printed mounts and standoffs
+===== Parts needed =====
-  * Flywoo AIO, silicone dampers and 4 motors
-  * Naked GoPro MAX 2: mainboard, dual-lens assembly, mainboard ribbon, BEC and mount parts
+  * OMNIX 360 Frame Kit
-  * Naked DJI O4 Pro: air unit, camera, camera cable, antennas and mounts
+  * Flywoo AIO (recommended: Flywoo AIO V3)
-  * XT30 pigtail, capacitor, XT30/capacitor holders and suitable wiring
+  * 4x Motors (recommended: T-Motor 1404 3800KV)
-  * Compatible receiver and antenna
+  * Naked GoPro MAX 2
-  * Small TPU washers (1.4 mm), large TPU washers (2.8 mm) and specified screws
+  * Naked DJI O4 Pro
-  * 4 propellers, GoPro lens covers, battery strap and optional battery adapter
+  * ELRS Receiver / CRSF Reciver
-  * Optional: GoPro speaker, touchscreen and O4 Pro cooling fan
+  * XT30 Power Cable
-  * Tools: hex drivers, precision screwdriver, soldering iron, flux, multimeter and smoke stopper
+  * Capacitor (470 25V)
+  * Propellers (Gemfan D2.5)
+  * 4S Battery (Tattu 650 LIHV)
+  * Naked Gopro Cable
-**Hardware note:** Check screw lengths and mounting clearances. Screws must not contact motor windings or PCBs.