Differences

This shows you the differences between two versions of the page.

--- public:naked-action-6-manual [2026/02/02 14:39] – [Step - Final Camera] admin
+++ public:naked-action-6-manual [2026/02/09 10:55] (current) – laurin
@@ Line 366: / Line 366: @@
   * Solder the positive and negative fan cables to the correct pads on the BEC.
-==== Step - Close the Case ====
+===== Step - Close the Case =====
 {{:public:naked_action_6_assemble__33_.jpg?nolink&800|}}
 {{:public:naked_action_6_assemble__34_.jpg?nolink&800|}}
@@ Line 386: / Line 386: @@
 {{:public:naked_action_6_pro_1_.jpg?nolink&800|}}
   * Add a ND Filter to protect the camera lens
+===== Gyroflow Fix =====
+In its naked configuration, the DJI Action 6 camera may exhibit stabilization artifacts after processing footage with Gyroflow. These issues are caused by slight movement of the sensor PCB and its onboard gyro.
+To resolve this, place a piece of foam between the rear cover and the sensor PCB. The foam must apply firm pressure to securely fix the sensor assembly. Correct pressure is achieved when the rear cover needs to be pressed onto the camera by hand before inserting the screws.
+When installed correctly, this fix prevents micro-movement of the sensor and results in smooth, reliable video output, significantly improving stabilization performance when using Gyroflow or RockSteady.
+Our recommendation for Gyroflow settings are:
+  * Low pass filter: 50hz
+  * Disable rolling shutter correction
+{{:public:action_6_foam_1.jpeg?nolink&800|}}
+{{:public:action_6_foam_5.jpeg?nolink&800|}}
+{{:public:action_6_foam_6.jpeg?nolink&800|}}
+{{:public:action_6_foam_2.jpeg?nolink&800|}}
+{{:public:action_6_foam_4.jpeg?nolink&800|}}
 ===== BEC Power Pinout =====