Differences

This shows you the differences between two versions of the page.

--- public:flowxminiv2 [2026/02/17 10:42] – laurin
+++ public:flowxminiv2 [2026/02/17 10:50] (current) – laurin
@@ Line 226: / Line 226: @@
 {{ :public:flowxmini2_diy_buildmanual-67.jpg?nolink&600 |}}
 Install the GPS on the frame and plug the connector to the fc.
+{{ :public:flowxmini2_diy_buildmanual-80.jpg?nolink&600 |}}
+Screw on the TPU O4/O3 Mount with M1,6x8mm Screws.
 {{ :public:flowxmini2_diy_buildmanual-81.jpg?nolink&600 |}}
 Secure the GPS module with shrinktube or tape.
-{{ :public:flowxmini2_diy_buildmanual-80.jpg?nolink&600 |}}
-Screw on the TPU O4/O3 Mount with M1,6x8mm Screws.
+{{ :public:flowxmini2_diy_buildmanual-82.jpg?nolink&600 |}}
+Screw on the O4/O3 Air unit. Then Open up the O4/O3 Air unit by unscrewing the screws on top and carrefully remove the VTX antennas.
+{{ :public:flowxmini2_diy_buildmanual-78.jpg?nolink&600 |}}
+Carefully feed the antennas through the TPU VTX Antenna mount.
+{{:public:flowxmini2_diy_buildmanual-83.jpg?nolink&400|}} {{ :public:flowxmini2_diy_buildmanual-84.jpg?nolink&400|}}
+Reconnect the Antennas to the UFL Connectors on the VTX. Close the VTX by screwing down the top screws.
+Push the TPU VTX antenna mount on the rear standoffs.
+{{ :public:flowxmini2_diy_buildmanual-86.jpg?nolink&600 |}}
+Screw on the first side of the camera pod with M2x