Differences

This shows you the differences between two versions of the page.

--- public:rangex-epic-diy-manual [2024/02/08 22:36] – admin
+++ public:rangex-epic-diy-manual [2024/12/09 18:01] (current) – ↷ Page moved from internal:public:rangex-epic-diy-manual to public:rangex-epic-diy-manual admin
@@ Line 43: / Line 43: @@
 ==== Step - Electronics preparation ====
-{{:public:rangex_epic_led.jpg?400|}}
 === LEDS ===
+{{:public:rangex_epic_led.jpg?400|}}
 Solder AWG XY wire to the the + and - pad's of the cob led strip. Then apply double sided tape to the cob led strip. Then we recommend to coat the solder connection with silcone coating.
+=== ESC ===
 {{:public:rangex_epic_esc.jpg?400|}}
-=== ESC ===
 Solder a AWG XY wire to the + and - pad's of the esc. Also solder two additional red and black AWG XY wires the + and - pad's of the esc.
+=== Receiver ===
 {{:public:rangex_epic_rx.jpg?400|}}
-=== Receiver ===
+Grab your TBS Diversity RX and solder the following 5 wires provided with the rx.
-Grab your TBS Diversity RX and solder the following 5 wires provided with the rx. Red --> RX 5v, Black RX --> GND, Yellow --> RX TX, White --> RX RX --> Green --> RX CH5. We also recommend to coat the rx.
+  * Red --> RX 5v
+  * Black --> RX GND
+  * Yellow --> RX TX
+  * White --> RX RX
+  * Green --> RX CH5
+  * We also recommend to coat the rx.
+=== FC ===
 {{:public:rangex_epic_fc.jpg?400|}}
-=== FC ===
 Grab your FC, add the silicone standoffs and coat the underside of it. Then solder the TBS diversity RX to the FC using the 4 wires. You can also solder two wires providing 5v and GND for the rc switch. You can also see that we pretinned the gps connections.
+=== DJI O3 ===
 {{:public:rangex_epic_o3.jpg?400|}}
-=== DJI O3 ===
 Grab your O3 unit and then loosen the two front facing + screws on the bottom of the unit.
 Now remove the camera connector carefully.