Differences

This shows you the differences between two versions of the page.

--- public:nakex25v2 [2026/02/11 10:11] – laurin
+++ public:nakex25v2 [2026/02/11 13:40] (current) – [Step 29 – Battery Pads] laurin
@@ Line 223: / Line 223: @@
 ===== Step 17 – Receiver Installation =====
-{{:public:nakex_2.5_diy_buildmanual-43.jpg?nolink&400|}}{{ :public:nakex_2.5_diy_buildmanual-38.5.png?nolink&400|}}
+{{ :public:nakex_2.5_diy_buildmanual-43.jpg?nolink&600 |}}
 • Install the receiver
@@ Line 234: / Line 234: @@
 – Receiver
+• Alternatively to shrinktube, tape can be used. If you decide to do this, wait until the VTX antennas are installed.
 • Secure the assembly by screwing in the XT30 PCB plate
@@ Line 250: / Line 252: @@
 ===== Step 20 – O4 Antenna Modification =====
-{{ :public:nakex_2.5_diy_buildmanual-47.jpg?nolink&600 |}}
-• Remove the four screws from the O4 air unit
 {{ :public:nakex_2.5_diy_buildmanual-49.jpg?nolink&600 |}}
+• Remove the four screws from the O4 air unit
 • Carefully lift the cover
@@ Line 265: / Line 267: @@
 {{ :public:nakex_2.5_diy_buildmanual-51.jpg?nolink&600 |}}
-• Push the antennas through the shrink tube
+• Push the antennas through the TPU mount and shrink tube
 • Using pliers to gently open space can help
@@ Line 327: / Line 329: @@
 ✔ Improved airflow to electronics
+✔ Sexy
 ===== Finish =====
 {{ :public:nakex_2.5_diy_buildmanual-62.jpg?nolink |}}