Differences

This shows you the differences between two versions of the page.

--- public:nakex25v2 [2026/02/11 10:08] – laurin
+++ public:nakex25v2 [2026/03/16 16:08] (current) – admin
@@ Line 1: / Line 1: @@
+{{htmlmetatags>metatag-og:image=(https://wiki.fpvframe.ch/_media/public:icon_fpvframe.png)}}
 ====== NakeX 2.5 Frame Build Manual ======
@@ Line 94: / Line 96: @@
 • Apply conformal coating to the bottom side of the flight controller
-• Only do this if you do not plan to solder anything else on that side
+• Only do this if you do not plan to solder anything additional like GPS or LEDs on that side
-Note:
-If you are using the Flywoo Goku GN745 (recommended), this step is not required.
 Tip:
@@ Line 117: / Line 118: @@
 Soldering setup:
 • Temperature: 450 °C
-• Solder: TBS solder
+• Solder: TBS solder (recommended)
 ===== Step 5 – Motor Wire Preparation =====
@@ Line 223: / Line 225: @@
 ===== Step 17 – Receiver Installation =====
-{{:public:nakex_2.5_diy_buildmanual-43.jpg?nolink&400|}}{{ :public:nakex_2.5_diy_buildmanual-38.5.png?nolink&400|}}
+{{ :public:nakex_2.5_diy_buildmanual-43.jpg?nolink&600 |}}
 • Install the receiver
@@ Line 234: / Line 236: @@
 – Receiver
+• Alternatively to shrinktube, tape can be used. If you decide to do this, wait until the VTX antennas are installed.
 • Secure the assembly by screwing in the XT30 PCB plate
@@ Line 250: / Line 254: @@
 ===== Step 20 – O4 Antenna Modification =====
-{{ :public:nakex_2.5_diy_buildmanual-47.jpg?nolink&600 |}}
-• Remove the four screws from the O4 air unit
 {{ :public:nakex_2.5_diy_buildmanual-49.jpg?nolink&600 |}}
+• Remove the four screws from the O4 air unit
 • Carefully lift the cover
@@ Line 265: / Line 269: @@
 {{ :public:nakex_2.5_diy_buildmanual-51.jpg?nolink&600 |}}
-• Push the antennas through the shrink tube
+• Push the antennas through the TPU mount and shrink tube
 • Using pliers to gently open space can help
@@ Line 327: / Line 331: @@
 ✔ Improved airflow to electronics
+✔ Sexy
 ===== Finish =====
 {{ :public:nakex_2.5_diy_buildmanual-62.jpg?nolink |}}