Differences

This shows you the differences between two versions of the page.

--- public:naked-action-6-manual [2026/02/09 10:55] – laurin
+++ public:naked-action-6-manual [2026/03/16 16:08] (current) – admin
@@ Line 1: / Line 1: @@
+{{htmlmetatags>metatag-og:image=(https://wiki.fpvframe.ch/_media/public:icon_fpvframe.png)}}
 ====== Naked Action 6 DIY Manual ======
@@ Line 228: / Line 230: @@
 ==== Step - Mainboard Preparation ====
-** There are some very small components next to where you will need to solder. Be careful to not damage or desolder any of the mainboard components during the following steps. **
+** There are some very small components next to where you will need to solder. Be careful to not damage or desolder any of the mainboard components during the following steps. If you are not comfortable doing this you can skip to the next step and do the alternative version**
 {{:public:action_5_disassemble_60_.jpg?nolink&800|}}
@@ Line 243: / Line 245: @@
+==== Step - Mainboard Preparation Alternative Version ====
+If you did the step above skip this. If you are not comfortable doing the step above you can do the preparation like shown below. It will add a bit of weight to the build.
+{{:public:naked_action_6_pro_connector_1.jpg
+?nolink&800|}}
+{{:public:naked_action_6_pro_connector_2.jpg
+?nolink&800|}}
+Solder the powercables directly to the battery connector of the mainboard.
 ==== Step - Back Display Preperation ====