Differences

This shows you the differences between two versions of the page.

--- public:naked-action-6-manual [2026/02/02 14:39] – [Step - Final Camera] admin
+++ public:naked-action-6-manual [2026/03/16 16:08] (current) – admin
@@ Line 1: / Line 1: @@
+{{htmlmetatags>metatag-og:image=(https://wiki.fpvframe.ch/_media/public:icon_fpvframe.png)}}
 ====== Naked Action 6 DIY Manual ======
@@ Line 228: / Line 230: @@
 ==== Step - Mainboard Preparation ====
-** There are some very small components next to where you will need to solder. Be careful to not damage or desolder any of the mainboard components during the following steps. **
+** There are some very small components next to where you will need to solder. Be careful to not damage or desolder any of the mainboard components during the following steps. If you are not comfortable doing this you can skip to the next step and do the alternative version**
 {{:public:action_5_disassemble_60_.jpg?nolink&800|}}
@@ Line 243: / Line 245: @@
+==== Step - Mainboard Preparation Alternative Version ====
+If you did the step above skip this. If you are not comfortable doing the step above you can do the preparation like shown below. It will add a bit of weight to the build.
+{{:public:naked_action_6_pro_connector_1.jpg
+?nolink&800|}}
+{{:public:naked_action_6_pro_connector_2.jpg
+?nolink&800|}}
+Solder the powercables directly to the battery connector of the mainboard.
 ==== Step - Back Display Preperation ====
@@ Line 366: / Line 379: @@
   * Solder the positive and negative fan cables to the correct pads on the BEC.
-==== Step - Close the Case ====
+===== Step - Close the Case =====
 {{:public:naked_action_6_assemble__33_.jpg?nolink&800|}}
 {{:public:naked_action_6_assemble__34_.jpg?nolink&800|}}
@@ Line 387: / Line 400: @@
   * Add a ND Filter to protect the camera lens
-=== BEC Power Pinout ===
+===== Gyroflow Fix =====
+In its naked configuration, the DJI Action 6 camera may exhibit stabilization artifacts after processing footage with Gyroflow. These issues are caused by slight movement of the sensor PCB and its onboard gyro.
+To resolve this, place a piece of foam between the rear cover and the sensor PCB. The foam must apply firm pressure to securely fix the sensor assembly. Correct pressure is achieved when the rear cover needs to be pressed onto the camera by hand before inserting the screws.
+When installed correctly, this fix prevents micro-movement of the sensor and results in smooth, reliable video output, significantly improving stabilization performance when using Gyroflow or RockSteady.
+Our recommendation for Gyroflow settings are:
+  * Low pass filter: 50hz
+  * Disable rolling shutter correction
+{{:public:action_6_foam_1.jpeg?nolink&800|}}
+{{:public:action_6_foam_5.jpeg?nolink&800|}}
+{{:public:action_6_foam_6.jpeg?nolink&800|}}
+{{:public:action_6_foam_2.jpeg?nolink&800|}}
+{{:public:action_6_foam_4.jpeg?nolink&800|}}
+===== BEC Power Pinout =====
 {{:public:A5_bec_pinout.jpeg?nolink&800|}}
 {{:public:A5_bec_pinout_2.jpeg?nolink&800|}}