This manual will guide you step by step through the assembly of your FlowX V3 Frame.

Begin with the top plate, making sure the countersunk side is facing downward.

Insert M3x12 mm screws and position the arms as shown above.

Add the middle plate and tighten all screws securely.

Install the 6 mm TPU spacers using M3x15 mm screws.

If you are using the TBS Lucid Flight Stack, install the Gorilla Mount as shown above. If you are using a different stack, use M3x28 mm screws instead.

Install the TPU VTX mount for DJI O4 (Pro) or DJI O3 using M2x5 mm screws and aluminum washers on the backside of the plate.

Push the TPU pod mount into place and insert an M3x20 mm standoff into the designated holes, as shown above.

Prepare the battery plate by installing M3x20 mm screws along with four 3 mm TPU spacers.

Mount the battery plate through the rear 6 mm TPU spacers and the front TPU pod mount.

Flip the frame over. Your build should now look like the image above.

Install six M3x20 mm standoffs. Secure the two rear standoffs using M3x6 mm screws.

Slide the antenna and GPS mount onto the rear standoffs. Ensure the orientation matches the image above.

Attach the bottom pod mount to the two front standoffs and insert an M3x15 mm standoff through the designated hole.

Install the camera pod plates. For now, secure them only at the top pod mount using M3x8 mm screws.

Install the TPU RX mount and insert an M3x20 mm standoff into the front hole of the RX mount. Use M3x10 mm screws at the pod mount and M3x8 mm screws at the front RX mount. Before tightening the RX mount, slide both TPU stack covers into position on each side.

Install the bottom plate using two M3x6 mm screws.

Attach the front and rear TPU landing gear using M3x20 mm screws.

Assembly is now complete. Your FlowX V3 Frame is ready for the next build steps!