public:flowxv3
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| public:flowxv3 [2026/01/20 10:20] – laurin | public:flowxv3 [2026/03/16 16:08] (current) – admin | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | {{htmlmetatags> | ||
| + | |||
| ====== FlowX V3 Frame Build Manual ====== | ====== FlowX V3 Frame Build Manual ====== | ||
| Line 43: | Line 45: | ||
| TBS Lucid Flight Stack: | TBS Lucid Flight Stack: | ||
| - | • Install the Gorilla Mount as shown | + | Install the Gorilla Mount as shown |
| Other Flight Stacks: | Other Flight Stacks: | ||
| - | • Use M3x28 mm screws | + | Use M3x28 mm screws |
| Tip: Do not overtighten TPU parts. | Tip: Do not overtighten TPU parts. | ||
| Line 81: | Line 83: | ||
| • Guide screws through: | • Guide screws through: | ||
| + | |||
| – Rear 6 mm TPU spacers | – Rear 6 mm TPU spacers | ||
| + | |||
| – Front TPU pod mount | – Front TPU pod mount | ||
| Line 131: | Line 135: | ||
| • Use: | • Use: | ||
| + | |||
| – M3x10 mm screws at the pod mount | – M3x10 mm screws at the pod mount | ||
| + | |||
| – M3x8 mm screws at the RX mount | – M3x8 mm screws at the RX mount | ||
public/flowxv3.1768904409.txt.gz · Last modified: by laurin