Start with the Top Plate, the countersinking facing downward.

Add M3Sx12mm Screws and place the Arms like shown above.

Ad the Middle Plate and tighten the screws.

Install 6mm TPU Spacers with M3Sx15mm screws.

If you use the TBS Lucid Flight Stack, install the Gorilla Mount as shown above. If another Stack is used use M3sx28mm Screws.

Add the TPU VTX Mount for DJI O4 (Pro) or DJI O3 Using M2x5mm Screws and Aluminium washers on the backside of the Plate.

Push the TPU Pod Mount in place and shove a M3x20mm Standoff in the provided holes as shown above.

Prepare the Battery Plate with M3x20mm Screws and 4 3mm TPU Spacers.

Install the Battery Plate through the rear 6mm TPU Spacers and the front TPU Pod Mount.

When flipped over, your build should look like this.

Install 6 M3x20mm Standoffs. Use 2 M3x6mm Screws on the rear two standoffs.

Push the antenna & GPS Mount onto the rear Standoffs. Be shure to have the orientation right as shown above.

Push the Pod Top Mount on the two front Standoffs and add a M3x15mm Standoff through the designated holes.