This is an old revision of the document!
Table of Contents
FlowX Mini V2 Frame Build Manual
Introduction
Welcome to the FlowX Mini V2 Frame Build Manual. This guide will walk you through the complete assembly process step by step.
Step 1 – Mount Arms on Bottom Plate
• Place the bottom plate on a flat surface • Mount the arms as shown • Secure using M3x10 mm screws
Step 2 – Middle Plate
• Add the middle plate • Align all arms correctly • Tighten the screws to lock the arms in place
Step 3 – TPU Bottom Pod Mount
• Press an M2x20 mm standoff into the TPU bottom pod mount • Insert the mount into the gap between the bottom plate and middle plate • Secure with two M2x8 mm screws
Step 4 – TPU RX Mount
• Mount the TPU RX mount above the AIO • Secure using M2x12 mm screws
Step 5 – TPU VTX Mount
• Install the TPU VTX mount using M2x5 mm screws • Place the DJI O4 / O3 unit on top of the mount
Step 6 – TPU Antenna & GPS Mount
• Install two M2x20 mm standoffs using M2x8 mm screws • Place the TPU antenna mount as shown
Optional: • If using a GPS, install the TPU GPS mount beneath the antenna mount
Step 7 – Prepare TPU Pod Top & Capacitor Mount
• Press M2x20 mm standoffs into the designated holes • Prepare both the TPU pod top mount and capacitor mount
Step 8 – Install Pod Mount on Frame
• Install the TPU pod mount • Position it at the front of the middle plate
Step 9 – Pod Plates
• Attach both pod plates • Secure using M2x8 mm screws
Step 10 – Top Plate
• Install the top plate • Secure with M2x8 mm screws
Step 11 – TPU RX Antenna Mount
• Install the TPU RX antenna mount using zip ties • Slide the antenna into the mount • Secure it with a second zip tie wrapped around the mount and arm
Finish
✅ Congratulations! Your FlowX Mini V2 Frame is now fully assembled and ready for electronics installation.