This Manual will help you to build your FlowX Mini V2 rame

Start by mounting the Arms on the Bottom Plate using M3x10mm Screws as shown above.

Fix the Arms in place by screwing on the middle Plate.

Push a M2x20mm Standoff into the TPU bottom Pod Mount and install it in the gap between the Bottom and Middleplate using two M2x8mm Screws.

The TPU RX Mount is mounted above the AIO with M2x12mm Screws.

The TPU VTX Mount is installed with M2x5mm screws. The DJI O4/O3 is placed on top of it.

Install two M2x20mm Standoffs with M2x8mm Screws. Place the TPU Antenna Mount like shown above. If you use a GPS, the TPU GPS Mount goes beneath the Antenna Mount.

Prepare the TPU Pod Top and Capacitor Mount by Pressing M2x20mm Standoffsinto the designated holes.

Install the TPU Mount on the front of the Middle Plate.

Screw on both Pod Plates with M2x8mm Screws.

Screw on the Top Plate with M2x8mm Screws.

Install the TPU RX Antenna Mount with zipties. The Antenna slips into the mount and is secured with a second ziptie around the mount and arm.

Congrats! Your FlowX Mini V2 Frame is now complete!