Differences

This shows you the differences between two versions of the page.

--- public:flowxminiv2 [2026/02/17 13:08] – [Step 11 – Capacitor Preparation] laurin
+++ public:flowxminiv2 [2026/03/16 16:08] (current) – admin
@@ Line 1: / Line 1: @@
+{{htmlmetatags>metatag-og:image=(https://wiki.fpvframe.ch/_media/public:icon_fpvframe.png)}}
 ======= Introduction =======
 In this Manual we will walk you through the build process of the FlowX Mini V2.
@@ Line 211: / Line 213: @@
 • Solder securely
-Polarity:
 • Black = Ground / – (short leg)
@@ Line 242: / Line 242: @@
 • Cut and solder the naked action cam power wire to the FC power pads
-⚠️ Take your time — this step requires clean, precise solder joints.
+Take your time — this step requires clean, precise solder joints.
 ===== Step 14 – XT30 Connector (Optional) =====
@@ Line 345: / Line 345: @@
 • Push the TPU antenna mount onto the rear standoffs
+• Connect the VTX with the air unit cable.
 ===== Step 20 – Camera Pod =====
@@ Line 394: / Line 396: @@
 {{ :public:flowxmini2_diy_buildmanual-95.jpg?nolink&600 |}}
-🎉 Congratulations! Your build is complete!
+Congratulations! Your build is complete!
 All that’s left is Betaflight configuration, binding your transmitter and goggles, and installing propellers.
-You’re now ready to fly 🚀
+You’re now ready to fly.