Differences

This shows you the differences between two versions of the page.

--- public:flowxminiv2 [2026/02/17 12:49] – laurin
+++ public:flowxminiv2 [2026/03/16 16:08] (current) – admin
@@ Line 1: / Line 1: @@
-====== FlowX Mini V2 Frame Build Manual ======
+{{htmlmetatags>metatag-og:image=(https://wiki.fpvframe.ch/_media/public:icon_fpvframe.png)}}
-===== Introduction =====
+======= Introduction =======
-{{ :public:flowx_mini_ii_frame_manual-1.jpg?nolink |}}
+In this Manual we will walk you through the build process of the FlowX Mini V2.
+There is a frame only manual, and a complete Drone Manual.
+====== FlowX Mini V2 Frame Build Manual ======
 Welcome to the FlowX Mini V2 Frame Build Manual.
@@ Line 211: / Line 214: @@
 • Solder securely
-Polarity:
 • Black = Ground / – (short leg)
@@ Line 240: / Line 242: @@
 • Cut and solder the naked action cam power wire to the FC power pads
-⚠️ Take your time — this step requires clean, precise solder joints.
+Take your time — this step requires clean, precise solder joints.
 ===== Step 14 – XT30 Connector (Optional) =====
@@ Line 343: / Line 345: @@
 • Push the TPU antenna mount onto the rear standoffs
+• Connect the VTX with the air unit cable.
 ===== Step 20 – Camera Pod =====
@@ Line 392: / Line 396: @@
 {{ :public:flowxmini2_diy_buildmanual-95.jpg?nolink&600 |}}
-🎉 Congratulations! Your build is complete!
+Congratulations! Your build is complete!
 All that’s left is Betaflight configuration, binding your transmitter and goggles, and installing propellers.
-You’re now ready to fly 🚀
+You’re now ready to fly.