public:flowx-v2-diy-manual
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| public:flowx-v2-diy-manual [2024/06/11 13:17] – [Step - Stack Mount & ESC Prep] laurin | public:flowx-v2-diy-manual [2024/12/09 18:01] (current) – ↷ Page moved from internal:public:flowx-v2-diy-manual to public:flowx-v2-diy-manual admin | ||
|---|---|---|---|
| Line 46: | Line 46: | ||
| ==== Step - ESC ==== | ==== Step - ESC ==== | ||
| - | Now shorten the cables so they can reach the corresponding ESC pad. We recommend to leave some spare wire so don't cut too tight. Strip the end of the wire and solder it to the pad. We recoomend | + | Now shorten the cables so they can reach the corresponding ESC pad. We recommend to leave some slack so don't cut too tight. Strip the end of the wire and solder it to the pad. We recommend |
| Now add the XT60 connector by shortening the + wire the amount the + and - pads are apart from the ESC. Strip the end of the fire and solder it to the + pad of the ESC. Now solder a red cable for the capacitor to the + pad of the ESC. Then solder a black cable for the capacitor to the - pad of the ESC. And to finish the power connection solder the - cable of the XT60 to the - pad on the ESC. | Now add the XT60 connector by shortening the + wire the amount the + and - pads are apart from the ESC. Strip the end of the fire and solder it to the + pad of the ESC. Now solder a red cable for the capacitor to the + pad of the ESC. Then solder a black cable for the capacitor to the - pad of the ESC. And to finish the power connection solder the - cable of the XT60 to the - pad on the ESC. | ||
public/flowx-v2-diy-manual.1718111855.txt.gz · Last modified: (external edit)