Differences

This shows you the differences between two versions of the page.

--- public:flowx-v2-diy-manual [2024/06/11 13:17] – [Step - ESC] laurin
+++ public:flowx-v2-diy-manual [2024/12/09 18:01] (current) – ↷ Page moved from internal:public:flowx-v2-diy-manual to public:flowx-v2-diy-manual admin
@@ Line 43: / Line 43: @@
 ==== Step - Stack Mount & ESC Prep ====
-Add the ESC spacer to the midplate and secure it by screwing 4x 28mm M3 screws from the bottomplate through the spacer. Now take your ESC and pretinn all the pads with solder. Now insert the four silicon grommets to the ESC. You can now push it down onto the ESC spacer by sliding it down the screws.
+Add the ESC spacer to the midplate and secure it by screwing 4x 28mm M3 screws from the bottomplate through the spacer. Now take your ESC and pretinn all the pads with solder. Now insert the four silicon grommets to the ESC. You can now push it down onto the ESC spacer by sliding it onto the stack screws.
 ==== Step - ESC ====
-Now shorten the cables so they can reach the corresponding ESC pad. We recommend to leave some spare wire so don't cut too tight. Strip the end of the wire and solder it to the pad. We recoomend to solder hot but quick in order to not damage the ESC. Do this for all four motors.
+Now shorten the cables so they can reach the corresponding ESC pad. We recommend to leave some slack so don't cut too tight. Strip the end of the wire and solder it to the pad. We recommend to solder hot but quick in order to not damage the ESC. Do this for all four motors.
 Now add the XT60 connector by shortening the + wire the amount the + and - pads are apart from the ESC. Strip the end of the fire and solder it to the + pad of the ESC. Now solder a red cable for the capacitor to the + pad of the ESC. Then solder a black cable for the capacitor to the - pad of the ESC. And to finish the power connection solder the - cable of the XT60 to the - pad on the ESC.