Using this guide you can unlock your DJI FPV video system aka FCC hack.

Use this guide at your own responsibility.

You have to check with your local law regulations regarding transmission frequencies and transmission power.

TBS Crossfire

1. Turn on your transmitter
2. Enter Bind mode on your transmitter
3. Power up the receiver on the drone. Depending on the model USB power might suffice, otherwise you need to connect the Battery. Only do this with propellers removed.
4. Press the bind button on the Crossfire receiver (check picture below for button location). This needs to be done within 20s after powering the RX.
5. Confirm bind procedure on your TX.

Depending on the transmitter used, the channel mapping needs to be adapted. This setting can be found in the receiver tab (check picture below). Changing from TAER to AETR or vice versa is usually enough. Make sure the channels on the left side align with your stick axis.

1. Turn on your DJI Goggle
2. Connect the battery to your BNF model. Only do this with props removed or a smokestopper.
3. Wait until the green LED appears on the DJI VTX.
4. Press the red button on your DJI Goggle twice. It should beep twice every second.
5. Press the button on the DJI VTX. The goggle confirms the binding by beeping twice.

The Stock configuration of our BNFs is made for TBS Tango 2 with the following switch assignments.

If you want to change the function of the buttons on your remote controller you need to assign AUX channels to each flight mode. This can be done within Betaflight.

1. Connect the drone via USB port of the flight controller to your computer
2. launch Betaflight configurator
3. Connect to the correspondent port
4. Navigate to “Modes” tab
5. Choose AUTO for the mode in question and press the corresponding button on your TX
6. Dont forget to hit save!

For all models that support GPS rescue: The GPS rescue should not be activated if you are within 100m of the starting point. If the drone is within 100m radius of the starting point and GPS rescue is activated, the drone will drop form the sky. Only activate GPS Rescue manually if the drone is more than 100m away from its starting point.

Rates affect the flight feel and determine the maximum speed of rotation around each axis for your drone. Our presets allow smooth and cinematic flight, but it is a good idea to experiment with the rates on order to find your personal settings.

1. Connect the drone via USB port of the flight controller to your computer
2. launch Betaflight configurator
3. Connect to the correspondent port
4. Navigate to “PID” tab
5. Swap to “Rateprofile settings” tab
6. Adapt the parameters to your needs
7. Dont forget to hit save!