Differences

This shows you the differences between two versions of the page.

--- public:cityflitzer [2026/02/24 13:54] – [Step 7 – Side Plates & Bottom Cover (Test Fit)] laurin
+++ public:cityflitzer [2026/02/24 14:07] (current) – [Step 13 – Camera Installation] laurin
@@ Line 55: / Line 55: @@
 ===== Step 6 – Flight Controller Coating & Soldering =====
-{{ :public:cityflitzer_build_manual-30.jpg?nolink&600 |}} {{ :public:cityflitzer_build_manual-25.jpg?nolink&600 |}}
+{{ :public:cityflitzer_build_manual-25.jpg?nolink&600 |}}{{ :public:cityflitzer_build_manual-30.jpg?nolink&600 |}}
+• Pre-assemble the side plates and TPU bottom cover
+• Use M2x20mm standoffs and M2x4mm screws
+• Use this assembly to measure correct wire lengths, do not fully mount yet
 • Apply conformal coating to the bottom side of the FC
@@ Line 80: / Line 87: @@
 Conformal coating is clearly visible under UV light.
-===== Step 7 – Side Plates & Bottom Cover (Test Fit) =====
-• Pre-assemble the side plates and TPU bottom cover
-• Use M2x20mm standoffs and M2x4mm screws
-• Use this assembly to measure correct wire lengths, do not fully mount yet
 ===== Step 8 – Receiver (RX) Preparation =====
@@ Line 142: / Line 142: @@
 • Install the VTX camera using M2x4mm screws
+• Close the Bottom TPU cover with a M2x8mm screw through the latch in the front.
 ===== Step 14 – TPU Battery Mount =====
 {{ :public:cityflitzer_build_manual-55.jpg?nolink&600 |}}