Differences

This shows you the differences between two versions of the page.

--- public:cityflitzer-bnf-manual [2024/10/05 18:10] – laurin
+++ public:cityflitzer-bnf-manual [2024/12/09 18:01] (current) – ↷ Page moved from internal:public:cityflitzer-bnf-manual to public:cityflitzer-bnf-manual admin
@@ Line 17: / Line 17: @@
 For smooth, high-quality footage, we strongly recommend following the 90° shutter rule when configuring the O3 camera. In bright, sunny conditions, ND filters are essential to maintain optimal performance. Each BNF Cityflitzer comes with a set of ND filters included.
+{{:public:CF_manual-7.jpg?400|}}
+{{:public:CF_manual-8.jpg?400|}}
 ==== Lipo information ====
@@ Line 32: / Line 35: @@
 To remove the Hood, remove the 4 lowest screws that hold the pod together (2 on each side). The hood will then pop away. Make sure to put the standoffs in the slots before reassembly to make sure all screws can be tightened properly.
-{{:public:CF_manual-1.jpeg?400|}}
+{{:public:CF_manual-1.jpg?400|}}
-{{:public:CF_manual-10.jpeg?400|}}
+{{:public:CF_manual-10.jpg?400|}}
 ==== Binding your Remote Controller ====
@@ Line 42: / Line 45: @@
   * Enter Bind mode on your transmitter.
   * Power up the drone's receiver. USB power might suffice, or connect the battery (without propellers).
-  * Press the bind button on the Crossfire receiver within 20s of powering the RX.
+  * Press the bind button on the Crossfire receiver within 20s of powering the RX (alternatively the bind mode can be activated in betaflight RX tab)
   * Confirm the bind procedure on your TX.
@@ Line 75: / Line 78: @@
 {{:public:dji-goggles-2.jpg?400|}}
-{{:public:CF_manual-4.jpeg?400|}}
+{{:public:CF_manual-4.jpg?400|}}