Our BNFs are no toys. Please be aware of injury especially with the bigger models. Do not plug in the battery when on the bench unless propellers are removed or a smokestopper is used.

TBS Crossfire

1. Turn on your transmitter
2. Enter Bind mode on your transmitter
3. Power up the receiver on the drone. Depending on the model USB power might suffice, otherwise you need to connect the Battery. Only do this with propellers removed.
4. Press the bind button on the Crossfire receiver (check picture below for button location). This needs to be done within 2s after powering the RX.
5. Confirm bind procedure on your TX.

If you want to change the function of the buttons on your remote controller you need to assign AUX channels to each flight mode. This can be done within Betaflight.

1. Connect the drone via USB port of the flight controller to your computer
2. launch Betaflight configurator
3. Connect to the correspondant port
4. Navigate to “Modes” tab
5. Choose AUTO for the mode in question and press the corresponding button on your TX
6. Dont forget to hit save!

Rates affect the flight feel and determine the maximum speed of rotation around each axis for your drone. Our presets allow smooth and cinematic flight, but it is a good idea to experiment with the rates on order to find your personal settings.

1. Connect the drone via USB port of the flight controller to your computer
2. launch Betaflight configurator
3. Connect to the correspondant port
4. Navigate to “PID” tab
5. Swap to “Rateprofile settings” tab
6. Adapt the parameters to your need
7. Dont forget to hit save!