board_name AIKONF7
manufacturer_id AIKO
mcu_id 0037001e3431511932313835
signature 

# name: Gyrologger

# resources
resource SERIAL_TX 2 NONE
resource SDCARD_CS 1 B00
resource PINIO 1 A02
resource FLASH_CS 1 NONE

# feature
feature -RX_SERIAL
feature -TELEMETRY
feature -OSD
feature -AIRMODE
feature LED_STRIP
feature RX_SPI
feature RX_PINIO

# map
map AERT1234

# led
led 0 0,0::A:2

# color
color 1 120,0,255
color 3 0,0,255
color 6 120,0,20

# mode_color
mode_color 6 0 5
mode_color 6 1 2
mode_color 7 0 4

# aux
aux 0 26 0 900 1300 0 0

# master
set acc_calibration = 54,65,45,1
set mag_hardware = NONE
set baro_hardware = NONE
set serialrx_provider = SBUS
set rx_min_usec = 880
set rx_max_usec = 2120
set blackbox_device = SDCARD
set blackbox_mode = ALWAYS
set motor_pwm_protocol = PWM
set small_angle = 180
set pid_process_denom = 7
set sdcard_mode = SPI
set sdcard_spi_bus = 3
set osd_canvas_width = 30
set osd_canvas_height = 13
set debug_mode = GYRO_SCALED
set pinio_config = 2,129,1,1
set pinio_box = 40,0,42,43
set flash_spi_bus = 0
set craft_name = Gyrologger
set pilot_name = FPVFrame.ch

profile 0

profile 1

profile 2

profile 3

# restore original profile selection
profile 0

rateprofile 0

rateprofile 1

rateprofile 2

rateprofile 3

# restore original rateprofile selection
rateprofile 0

# save configuration
save