FlowX Mini V2 Frame Build Manual

Welcome to the FlowX Mini V2 Frame Build Manual. This guide will walk you through the complete assembly process step by step.

• Place the bottom plate on a flat surface • Mount the arms as shown • Secure using M3x10 mm screws

• Add the middle plate • Align all arms correctly • Tighten the screws to lock the arms in place

• Press an M2x20 mm standoff into the TPU bottom pod mount • Insert the mount into the gap between the bottom plate and middle plate • Secure with two M2x8 mm screws

• Mount the TPU RX mount above the AIO • Secure using M2x12 mm screws

• Install the TPU VTX mount using M2x5 mm screws • Place the DJI O4 / O3 unit on top of the mount

• Install two M2x20 mm standoffs using M2x8 mm screws • Place the TPU antenna mount as shown

Optional: • If using a GPS, install the TPU GPS mount beneath the antenna mount

• Press M2x20 mm standoffs into the designated holes • Prepare both the TPU pod top mount and capacitor mount

• Install the TPU pod mount • Position it at the front of the middle plate

• Attach both pod plates • Secure using M2x8 mm screws

• Install the top plate • Secure with M2x8 mm screws

• Install the TPU RX antenna mount using zip ties • Slide the antenna into the mount • Secure it with a second zip tie wrapped around the mount and arm

✅ Congratulations! Your FlowX Mini V2 Frame is now fully assembled and ready for electronics installation.